Symmons Unity S-6610-1.5 Manual De Operaciones Y Mantenimiento página 3

Installation
If replacing an older faucet
ensure water supply is turned
OFF before removing, then
turn faucet control valve ON to
relieve water pressure.
DO NOT use pipe dope
or thread sealant on drain
assembly, or any plastic
threaded components.
1) Insert faucet body (H) and
threaded rods (J) through mount-
ing gasket (N) and sink holes.
H
2) Place brackets (K) onto threaded
rods (J) and secure with nuts (L).
1
1
L
3) Seat flange (M2) into sink (M3
gasket optional). Install gasket
(M4), washer (M5) and nut (M6)
onto flange (M2) from below sink,
but do not secure nut. Screw on
tail piece (M7) and hand tighten.
PLUMBER
PUTTY
OPTIONAL
J
N
4) Turn tail piece (M7) and flange
(M2) so pivot is facing toward
faucet. Pull assembly down into
drain hole. Secure hardware from
below sink. Install stopper (M1) in
the removable or non-removable
position.
J
K
M2
2
M7
M2
M3
2
M4
M5
M6
M7
3
3
M1
2
PIVOT
3
5) Attach inner washer (M8), pivot
rod (M9) and outer washer (M10)
to tailpiece (M7). Hand tighten nut
(M11) to secure pivot rod (M9).
M9
M8
M7
6) Connect lift rod (E) to clevis strap
(M13) and secure with thumb
screw (M14). Insert pivot rod
(M9) through spring clip (M12)
and clevis strap (M13). Secure
with spring clip (M12) and adjust
linkage if necessary.
1
E
M13
M9
M13
M11
M10
M14
M12