Tuning In A Preset Station; Removing One Or More Presets; Alarm Clock Features; Setting The Alarm Time - Boston Acoustics Horizon Solo Manual Del Propietário

Tuning in a Preset Station

1
Turn the control to select Preset.
MODe
2
Turn the control to select the preset station you want.
tune
The Preset indicator, the preset number and the station
frequency will light.
In this example AM preset 5, with station frequency 1050 assigned to it,
has been selected.

Removing One or More Presets

To remove one preset – Tune in the preset station as described above. Press and hold the
When the Preset has been cleared the station frequency, "radio" and the AM/FM band indicator are replaced
with "_ _ _ _" .
Note: You must tune in the preset you want to delete with the Preset source. If you tune in a radio station
that has been placed in a preset using the AM or FM source, you will see the Preset indicator and number in
the display, but you will not be able to delete the preset.
To clear all the presets – Using the Preset source, tune in any preset station. Then press and hold the
control for 10 seconds. You'll hear 3 beeps indicating the presets have been cleared.

Alarm Clock Features

The Horizon Solo has two independent alarm settings. Each can have its own type of alarm —wake to tone,
wake to music or both. Both types of alarms start at a low volume level that gently increases.

Setting the Alarm Time

The alarm time can be set when the Solo is turned on or off.
1
Press and hold the
one second. The alarm time and the
icon will flash.
2
Turn the control to adjust the alarm time.
MODe
3
Press the control to set the alarm time.
MODe
In this example Alarm 2 is set to 7:15 AM.
Note: The alarm time can also be set by using the
control to highlight the
press the control and follow steps 2 and 3 above.
MODe
8
or button for
alarM 1 alarM 2
or icon. Then
or
MODe
control.
tune
tune