Kobalt SGY-AIR226 Manual Del Usuario página 13

REPLACING CUTTING DISC
2. Use the provided hex key (BB), loosen
and remove the hex key bolt by unscrewing
the bolt clockwise (See Figure 2).
NOTE This is a left handed bolt.
3. Using the provided wrench (AA), loosen
and remove the hex nut by turning it
counterclockwise, remove the nut and
washer, then remove cutting disc (See
Figure 3).
4. Place the new cutting disc (not included)
over the thread shaft (See Figure 4).
2
3
4
13
BB
D
E
B
E
B
AA
B
F