Kenmore 116.33922 Manual Del Propietário página 15

iiiiiiiiiii iii
Iiiiii!ili!!!iiiiiiiiiiiiiiiiiiiiil]iiil]iiiiii!i!!!i!!iii!!!!!ii !i ! i!!iiii!iiiiiiiiiiiiii_i iiii_ii!ii!_!_i_!i@i_!!_i!!_iii_i_;;_ iiii_i_@i_i !iiiiiiiiiiiiiiiiiii!iiiiiiiii]iiiiiiiiiiiiiiiiiiiiiiii
TO REMOVE DUST BAG
!
r._._WARNING
Always unplug power cord from
electrical outlet before performing
any service on vacuum.
Pull out on the
bag cover release
located near the
top of the bag
cover.
Bag Cover
Bag
Grasp the dust bag
collar and pull gently,
carefully removing .J_
the dust bag.
/
Throw away the used
dust bag.
Pull the bag
cover forward
and lift up.
Remove and lay
aside.
Dust
Bag
Do not reuse.
-ll=e/./o/de. Check the bag
holder and the
motor safety fil-
ter. If either is
blocked, check
_f_e/ TROUBLE-
R_=- SHOOTING
i CAUTION
NEVER REUSE A DUST BAG. Very
fine materials, such as carpet fresh°
ener, face powder, fine dust, plaster,
soot, etc. can clog the bag and
cause it to burst before it is full.
Change bag more often when vacu-
uming these materials.
TO REPLACE DUST BAG
Unfold the new
dust bag. Fold
the safety seal
tab on the new
dust bag away
from the open-
ing that tits on
the bag holder.
NOTE: See PARTS AND FEATURES for
bag number.
Insert the dust bag
_t onto the bag holder
completely by hold-
ing the bag collar.
t Place the dust bag
collar into position.
Tuck the bag
behind each of the Bag
four bag retention Re_o,
Corner
comer flaps shown Ft_
here. Be sure the
bottom and sides
of the dust bag are
completely within
bag cavity prior to
replacing the bag
cover.
1
Position the bag
cover so its posi-
tioning tabs fit
into the body
positioning tab
slots.
Close the bag
Cover.
You will hear a
distinct snap
when cover is
securely closed.
Check to see that the dust bag is fully
enclosed in the bag cover,
15