Handle Assembly - Kenmore 116.33922 Manual Del Propietário

iiiiiiiiiiii iiiiiiiiiiiiiiiiiiiiii!iiiiiiiiiiiiiiiiiiiiiii i! i ii__ili_i_i_i iii i i i iiiiiiiiiiiiiiiiiiilJ ii iiii!ii iiiiiiii ii
liiiiiiiiiiiiiiii!iii!iill ii i iiiiiiiiiiiiiii ill ii!iiii i!!!!iii!iiiiiiiiiiiiii!ii!!i!!!i!ii!ii!i_i_iiii!i_i_ i!!iill !_!!!i_i!i!i!i!iiii iiiiiiiii!iiiiiiiiiii_iiii iliii£i;iiiii iiiiiiiiiiiiiii iiiiiiiiiiiiii!i!!iiii!iiiiiiiiiiiiiiiiiiiiiii!!!i i i!!iiiiil
i WARNING
Electrical Shock Hazard
Do not plug into the electrical sup-
ply until the assembly is complete.
Failure to do so could result in elec-
trical shock or injury.
Before assembling vacuum check the
PACKING LIST on the cover of the separate
Repair Parts List. Use this list to verify that
you have received all the components of
your new Kenmore vacuum.
_ emove the
tape located
below the dust
covedfilter cover
on the motor
case,
Attach stretch hose
end to nozzle as
shown.
HANDLE ASSEMBLY
Remove the screw located just below the
top edge of the back of the vacuum.
Position the handle as shown in the illustra-
tion.
Slide the handle into the opening at the top
of the vacuum.
Handle
Screw
Hole
Insert the screw so it passes through the
handle into the vacuum.
1
Begin to tighten the screw with your fingers.
It may be necessary to adjust the handle
slightly.
Using a screwdriver
tighten the screw.
Do not overtighten.
Overtightening could strip the screw
holes.
Do not operate the cleaner without
the screw in place.