Mark MM Serie Instrucciones De Usuario página 6

ENGLISH
9. PRE
When the PRE switch is pressed, aux send 1 is sourced pre-fader.
10. AUX 2 (FX)
The aux send labeled FX is for sending to effects devices and is thus set up to
be post-fader.
In the FX, the FX send is routed directly to the built-in effects processor.
11. PAN
The PAN control determines the position of the channel signal within the stereo
image. This control features a constant-power characteristic, which means the
signal is always maintained at a constant level, irrespective of position in the
stereo panorama.
12. MUTE / SUB 1-2
You can use the MUTE / SUB 1-2 switch to divert the channel from the main
mix bus to the SUB 1-2 bus. This mutes the channel from the main mix.
13. MUTE LED
The MUTE LED indicates that the relevant channel is diverted to the submix
(SUB 1-2 bus).
14. CLIP LED
The CLIP LED lights up when the input signal is driven too high. In this case,
turn down the TRIM control and, if necessary, check the setting of the channel
EQ.
15. SOLO
The SOLO switch (FX only) is used to route the channel signal to the solo bus
(Solo In Place) or to the PFL bus (Pre Fader Listen). This enables you to
monitor a channel signal without affecting the main output signal. The signal
you hear is sourced either before (PFL, mono) or after (solo, stereo) both the
pan control and the channel fader.
16. CHANNEL FADER
The channel fader determines the level of the channel signal in the main mix
(or submix).
MM 804/1204/1604 E USB 4 User manual/Manual de Uso
AUX
0
1
- +15
9
0 PRE
2
10
FX
- +15
11
PAN
L R
1
12
MUTE
SUB 1-2
MUTE
dB
13
10
14
CLIP
15
0
SOLO
10
16
15
20
25
30
40
60
1