Celestron 44306 Manual De Instrucciones página 10

Plug the USB cable of the digital camera into the USB port of your computer.
Each computer system will have slightly different messages when you attach the
digital camera. For example, on some Vista OSs when plugged in the message
may say "Installing Device Driver Software" and shortly thereafter you may see
a message "Your Devices Are Ready to Use". Just follow any instructions
shown on the screen.
You will need to install the ArcSoft software to actually view and/or image and
prior to doing this you will need to unplug the USB cable. Note that if using a
MAC computer you will have to have an image capture program for your MAC
as ArcSoft will not work on MAC computers.
Installing the Viewing and Imaging Software
Your microscope comes with the ArcSoft Software CD-ROM which allows you
to use your microscope for visual purposes and for imaging with your computer.
Before installing the software, remove the USB cable of the Digital Camera
from your computer and do not connect it until the software installation is
complete. Insert the CD-ROM into your CD-ROM drive and it should
automatically begin. Messages will appear (each operating system may show
something somewhat different) to guide you through the installation process.
10