Operation - Beurer FC 72 Instrucciones Para El Uso

• Insert the water tank back into the device until it audibly clicks
into place.
• Adjust the angle of the nozzle to the required height.
Important
Do not adjust the nozzle when the device is in use! You could
sustain burn injuries to the hand.
• Wash your face with a damp cloth before using the device.

7. Operation

Do not use the ionic facial sauna for more than 15 minutes per day. It is recommended that two to
three treatments are performed per week.
After you have made the necessary preparations described in "Section 6. Initial use", you may start
the treatment.
To start the treatment, carry out the following steps:
• Connect the mains plug to the socket and press the ON/OFF
button.
The indicator lamp begins to light up blue and the ion function
is activated. The device starts to heat the distilled water. After
approximately 30 seconds, steam begins to flow from the nozzle.
After approximately 1 minute, the steam is strong enough and you
can begin the treatment.
• By pressing the ON/OFF button again, the indicator lamp lights up
red and the ion function is deactivated.
• Move your face slowly towards the flow of steam so that the steam
covers your entire face. The steam should feel pleasant and not too
hot. If you feel the steam is too hot, move further away from the
nozzle to prevent burn injuries.
Warning
Ensure that your face does not get closer than 25 cm to the nozzle.
Otherwise there is a danger of your facial skin becoming red or
sustaining burn injuries.
12