Cleaning; Disposal; Technical Data; Warranty / Service - Beurer FC 72 Instrucciones Para El Uso

Sauna facial iónica
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
The device shuts off automatically if there is no water left in the device or after 15 minutes.
• Remove the mains plug from the socket.
• After the treatment, wash your face with cold water. Now apply a facial cream or face mask.
The open pores allow the active agents to penetrate deep into the skin.
• Allow the device to cool down for 10 minutes. Afterwards, clean the device as described in
Section "8. Cleaning".

8. Cleaning

Prior to cleaning, make sure that the mains plug has been removed from the socket.
• After each use, empty and clean the water tank and remove any grease or other residue.
• The water tank is dishwasher-safe and can be cleaned in a dishwasher if required.
• After cleaning, place the water tank back in the device.
• Clean the nozzle and the base device with a soft, slightly damp cloth and then wipe dry.

9. Disposal

For environmental reasons, do not dispose of the device in the household waste at the end
of its useful life. Dispose of the unit at a suitable local collection or recycling point. Dispose
of the device in accordance with EC Directive – WEEE (Waste Electrical and Electronic
Equipment). If you have any questions, please contact the local authorities responsible for waste
disposal.

10. Technical data

Model no.
FC 72
Voltage supply
220-240V~50/60Hz
Output
260 W
Protection class II /
Short operation Max. 15 min

11. Warranty / service

In case of a claim under the warranty please contact your local dealer or the local representation
which is mentioned in the list "service international".
In case of returning the unit please add a copy of your receipt and a short report of the defect.
The following warranty terms shall apply:
1. The warranty period for BEURER products is either 3 years or- if longer- the country specific
warranty period from date of Purchase. In case of a warranty claim, the date of purchase has to
be proven by means of the sales receipt or invoice.
2. Repairs (complete unit or parts of the unit) do not extend the warranty period.
3. The warranty shall not be valid for damages because of
a. improper treatment, e.g. nonobservance of the user instructions.
b. repairs or tampering by the customer or unauthorised third parties.
c. transport from the manufacturer to the consumer or during transport to the service centre.
d. The warranty shall not be valid for accessories which are subject to normal wear and tear
(cuff, batteries etc.).
4. Liability for direct or indirect consequential losses caused by the unit are excluded even if the
damage to the unit is accepted as a warranty claim.
13

Publicidad

Tabla de contenido
loading

Tabla de contenido