Box Content P; Fastening The Grow-Up! P; Fastening Your Child P; Assembly And Disassmbly Of The Belts P - Mutsy grow-up! Manual De Instrucciones

English
Box content
- 1 Grow-up! base
- 1 Grow-up! inlay
- 1 five-point harness (drawing 2 / A1, A2, A3)
- 2 safety straps (drawing 2 / B1, B2)
- 1 connection strap (drawing 4 / D)
Fastening the Grow-up! booster seat on the chair
! Position the Grow-up! booster seat as close to
the back of the chair as possible and tighten
the safety belts as tightly as possible at the
bottom and back of the chair.
· Fasten safety belt B1 (drawing 3) around the
back of the chair.
· Fasten safety belt B2 (drawing 3) around the
chair's seat.
· All safety straps can be adjusted on one side
by sliding the adjusting mechanism along the
straps into the desired position. They can be
adjusted on the other side by feeding the far
end through the slot into the buckle.
Fastening your child
· Always secure the Grow-up! onto a dining chair
first and ensure that the safety belts are tigh-
tened at the bottom and back side of the chair
(drawing 3 / B1, B2) as much as possible. Only
then can the child be placed into the Grow-up!
· The Grow-up! Booster Seat is fitted with a five-
point harness. Always check whether the straps
are in place as shown in drawing 2. Make sure
that both shoulder straps (drawing 2 / A1) are at-
tached in such a way that they cannot be twisted.
! Always use the five-point harness.
· Position your child into the booster seat and
ensure that the middle strap is in between your
child's legs (drawing 1 / A3).
· Make sure that all of the straps on the five-
point harness (drawing 1 / A1, A2, A3) are ad-
justed to fit your child firmly and snugly.
· Close the safety five-point harness by clicking
the plastic buckles into position. (drawing 3 / A)
· The five-point harness can be adjusted by sli-
ding the adjusting mechanism over the straps
into the desired position.
· When your child is sitting in the Grow-up! and
has been fastened correctly, you can slide the
chair towards the table.
Assembly/Disassembly of the belts
· In order to disassemble the harness system,
loosen the connection belt (drawing 4 / D) by
14