Operation - Hart HPWL01 Manual Del Operador

OPERATION

WARNING:
Do not direct the light beam at persons or animals and
do not stare into the light beam yourself (not even from
a distance). Staring into the light beam may result in
serious injury or vision loss.
WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool. The use
of attachments or accessories not recommended can
result in serious personal injury.
APPLICATIONS
You may use this tool for the purpose listed below:
 G eneral illumination of most work area spaces
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 7.
Insert the battery pack into the battery port as shown.

Make sure the latch on the battery pack snaps into place

and the battery pack is secured in the product before
beginning operation.
Depress the latch and pull to release and remove the

battery pack.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
WARNING:
Always remove battery pack from the tool when you
are assembling parts, making adjustments, cleaning, or
when not in use. Removing battery pack will prevent ac-
cidental starting that could cause serious personal injury.
POWER BUTTON (HIGH/MEDIUM/LOW/OFF)
See Figure 2, page 7.
The work light will be in the OFF position until the power
button is pressed.
 C onnect the product to the battery pack.
 P ress and release the button once to activate HIGH mode.
 P ress and release the button again for MEDIUM mode.
 P ress and release the button again for LOW mode.
 P ress and release the button a fourth time to turn the
work light OFF.
NOTE: This light is equipped with a low voltage indicator. If
the light flashes 3 times while a battery pack is installed, this
indicates a low charge condition. Install a charged battery
pack and resume operation.
WARNING:
Battery-powered tools are always in operating condition.
Therefore, unit should always be in the OFF status,
with the battery pack removed when not in use. Do not
leave light on while unattended. Failure to follow these
instructions could result in serious personal injury.
WARNING:
Keep work light away from combustible materials. If
wrapped or in contact with fabrics, the work light lens
can produce sufficient heat to melt some fabrics. To
avoid serious personal injury, never allow the work light
lens to come in contact with anything.
ADJUSTABLE HEAD
See Figure 3, page 7.
CAUTION:
Do not place hands or fingers between adjustable head
and frame when positioning work light to avoid pinching
your fingers or hands.
The work light head can be set in a variety of positions. To
illuminate the desired area, pivot head to desired position.
TO HANG THE LED WORK LIGHT
See Figure 3, page 7.
WARNING:
Only hang or mount LED work light in an area where no
electrical wires, utility cables, pipes, or other obstructions
are located. Contact your local utility company or a
qualified electrician if you are unsure. Do not hang work
light from any electrical power cord. Ensure work light is
securely installed to prevent falling object hazard. Failure
to follow these instructions can result in electrocution,
electrical shock, or other serious personal injury.
Using the mounting recess to hang the light:
 Secure 2x wood into the material recess to mount the
light either horizontally or vertically. The body of the light
will clamp around the material.
NOTE: Be careful not to hang the work light in such a
way that it prevents normal work light operation.
5 – English