Windows System Requirements; Important Safety Instructions - Epson Perfection 1270 Instrucciones De Seguridad Importantes

Windows System Requirements

To use your scanner and its software, your system should have:
®
An IBM -compatible PC with a Pentium
®
Microsoft Windows
Windows XP (factory installed or upgraded from factory-installed Windows 98SE/2000/Me)
A minimum of 128MB of RAM (256MB recommended)
A minimum of 500MB available hard disk space for installing the software
CD-ROM or DVD drive (4× or faster)
Built-in USB port
Mouse or pointing device
SVGA or higher resolution color monitor with 800 × 600 screen resolution or higher and
16-bit color (High Color) (24-bit TruColor recommended)
Note: On-screen color and tone reproduction are subject to the display capability of your
computer system, including the video card, monitor, and software. See the documentation
for these products for details.

Important Safety Instructions

Read all these instructions and save them for later reference. Follow all warnings and instructions
marked on the scanner.
Caution: Be sure the AC power cord meets the relevant local safety standards.
Place the scanner close enough to the computer for the interface cable to reach it easily. Do not
place or store the scanner or the AC adapter outdoors, near excessive dirt or dust, water, heat
sources, or in locations subject to shocks, vibrations, high temperature or humidity, direct
sunlight, strong light sources, or rapid changes in temperature or humidity. Do not use with
wet hands.
When connecting the scanner to a computer or other device with a cable, ensure the correct
orientation of the connectors. Each connector has only one correct orientation. Inserting a
connector in the wrong orientation may damage both devices connected by the cable.
Place the scanner and the AC adapter near an electrical outlet where the power cord can be
easily unplugged.
Power supply cords should be placed to avoid abrasions, cuts, fraying, crimping, and kinking.
Do not place objects on top of power-supply cords and do not allow the AC adapter or
power-supply cords to be stepped on or run over. Be particularly careful to keep all
power-supply cords straight at the ends and points where they enter and leave the AC adapter.
Use only the AC adapter model A241B/E that comes with your scanner. Using any other
adapter could cause fire, electrical shock, or injury.
The AC adapter is designed for use with the scanner with which it was included. Do not
attempt to use it with other electronic devices unless specified.
®
II-equivalent or faster processor
®
98SE (factory installed), Windows Me, Windows 2000, or
9