1-10
Slide rack down into place. Insert screw
at (D) and tighten with a Phillips screw-
driver.
1-13
Position tool in holder at base of cleaner
and snap it into place as shown at
arrow.
1-16
G
To remove powered hand tool (G), pull it
down and outward.
To reposition the tool, reverse this pro-
cedure.
To remove the scrub module (H), grasp
it at the sides and pull it forward.
To reposition module, fit tabs in the stor-
age area into holes on back of module.
Push module to snap it securely into
position.
This is the proper storage location for
the module.
1-11
D
Storing hose & tools
Store hose on holder by first positioning
hose in front section of holder.
1-14
Slide bare floor attachment into holder
as shown.
1-17
H
How to reattach tool
cover
The tool cover is designed with a break-
away feature which allows it to snap free
if it is pushed open too far.
To reattach, align hinges of cover with
holes on sides of tool storage area.
1-12
F
E
Continue wrapping hose under lower
hook (E). Snap hose end fully into hold-
er (F).
Ensure that the hose end is pushed
down completely into holder (F).
1-15
Powered hand tool
The powered hand tool is shipped in a
plastic bag for protection. Remove the
bag before using the tool by first open-
ing tool door.
Continued §
5