Thermador RECHMWB30 Manual Del Usuario página 5

Cabinet Installation
First install deflector to the bottom of the Cabinet, then
install the Hood to the Deflector:
1. Find the centerline of the cabinet bottom. Draw a line
along this centerline from rear to front of the cabinet.
2. Draw two lines, one at a 2
the other one at a 7 ⁄
1
16
line. Mark 4 points , two along each line at a distance of
half W from the center line, to determine the screw
locations.
W: RECHMWB36: 29
RECHMWB30: 34
3. Fit 4 screws on cabinet bottom (screws not supplied) do
not tighten completely but leave a space of about
from cabinet bottom surface and head screws.
Note: the screws must be suitable to support the hood/
deflector wieght and must be the right type according
with the bottom cabinet surface.
4. Hang the Deflector on screws through side slots
provided on deflector top. Tighten the four screws
through slots.
5. Fit four screws on bottom of the deflector, do not
tighten completely.
6. Install the Hood on bottom of the Deflector so that
screws and pins go respectively into Side Slots on
top of the hood and Side Slots on bottom of Deflector,
slide the hood rearward until it stops.
7. Remove 1 of 2 knockouts and install
connector in j-box.
8. Fit screws, from inside the hood to final assembly
deflector to the hood.
9. Proceed to install hood as described on the Installation
Manual.
⁄ " distance from the wall,
1
2
" distance from the previous
W
CL 7
1
2 /
1
Screw for
cabinet
bottom
installation
⁄ " (740 mm)
2
16
⁄ "(887 mm)
15
16
⁄ " conduit
1
2
Charcoal filter
In the recirculating mode, the air will be recirculated
through disposable charcoal filters that help remove smoke
and odors.
• Remove the grease filter of the hood.
• Cover the grill that protects the suction motor with the
charcoal filter so that the slots on the filter correspond
to the pins on the sides of the motor protection grill.
• Turn the carbon filter clockwise to block them (bayonet
fixing).
NOTE: The charcoal filters cannot be cleaned. Filters
should be replaced every 4-6 months (depending on hood
usage).
/ "
16
"
2
⁄ "
1
2
Page 5