PROBLEM
Unit will not idle
Unit idles even with load plugged in
Unit tries to idle but won't stay latched
Warranty Coverage: Powermate Corporation (the Company) warrants to the original retail customer in North America that it will
repair or replace, free of charge, any parts found by the Company or its authorized service representative to be defective in
material or workmanship. This warranty covers the cost of replacement parts and labor for defects in material or workmanship.
Not Covered:
·
Transportation charges for sending the product to the Company or its authorized service representative for warranty service,
or for shipping repaired or replacement products back to the customer; these charges must be borne by the customer.
·
Engine is covered exclusively by a separate warranty from the engine manufacturer, included with the engine Manual.
·
Damages caused by abuse or accident, and the effects of corrosion, erosion and normal wear and tear.
·
Warranty is voided if the customer fails to install, maintain and operate the product in accordance with the instructions and
recommendations of the Company set forth in the owner's manual.
·
The Company will not pay for repairs or adjustments to the product, or for any costs or labor, performed without the
Company's prior authorization.
Warranty Period: Two (2) years from the date of purchase on products used solely for consumer applications; if a product is
used for business or commercial applications, the warranty period will be limited to one (1) year from the date of purchase; if a
product is used for rental applications, the warranty period will be limited to ninety (90) days from the date of purchase. For
warranty service, the customer must provide dated proof of purchase and must notify the Company within the warranty period.
For warranty service: Call toll free 800-445-1805, or write to Powermate Corporation, Product Services, 4970 Airport
Road, P. O. Box 6001, Kearney, NE 68848.
EXCLUSIONS AND LIMITATIONS: THE COMPANY MAKES NO OTHER WARRANTY OF ANY KIND, EXPRESS OR IMPLIED.
IMPLIED WARRANTIES, INCLUDING WARRANTIES OF MERCHANTABILITY AND OF FITNESS FOR A PARTICULAR
PURPOSE, ARE HEREBY DISCLAIMED. THE WARRANTY SERVICE DESCRIBED ABOVE IS THE EXCLUSIVE REMEDY
UNDER THIS WARRANTY; LIABILITY FOR INCIDENTAL AND CONSEQUENTIAL DAMAGES IS EXCLUDED TO THE EXTENT
PERMITTED BY LAW.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Some states do
not allow a disclaimer of implied warranties, or the exclusion or limitation of incidental and consequential damages, so the above
disclaimers and exclusions may not apply to you.
English
IDLE CONTROL TROUBLE SHOOTING
POSSIBLE CAUSE
Control panel switch not on
Load plugged into receptacle
Poor connection or faulty cord
Bad I.C. module; Bad electro-magnet
or solenoids; Bad stator
Load not heavy enough
Bad I.C. module
Electro-magnet or solenoid position
incorrect
Flapper bracket loose or bent
Engine not running smoothly
LIMITED WARRANTY
SOLUTION
Turn to idle on position
Unplug load
Check & repair
Replace
Consult dealer
Turn idle switch to off position
Increase load
Replace
Consult dealer
Reset magnet or solenoid position for
2200 RPM idle speed
Consult dealer
Tighten or straighten
Replace flapper. Readjust to 2200 RPM
Adjust carburetor
Consult dealer
3