Product Maintenance - Fellowes AutoMax 150C Manual Del Usuario

ADVANCED PRODUCT FEATURES
SilentShred™ Technology
shreds without noisy disruptions.
SLEEP MODE OPERATION
Feature shuts down the shredder after 2 minutes of inactivity
WHEN IN SLEEP MODE
1
2
or
lid and load paper
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com

PRODUCT MAINTENANCE

OILING SHREDDER
recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1 2
*Carefully apply oil
Open lid
across cutters (do not
get oil in paper tray)
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
TROUBLESHOOTING
will remain illuminated and the shredder will not operate for the duration of the recovery time.
* Shredder will not run when lid is open.
MISALIGNED PAPER
1
If paper is not shredding
check position of paper.
4
Insert paper
3
Close lid. Press and
hold forward ( )
2-3 seconds
2
Paper should be flat and
aligned with front of
paper tray.
Energy Saving Sleep Mode
Feature shuts down the shredder
after 2 minutes of inactivity
CLEANING AUTO-START INFRARED SENSORS
may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: the paper detection sensors is located in the center of the paper entry).
TO CLEAN THE SENSORS
1
2
Open lid
shredder
3
4
Locate Auto-start Dip cotton swab in
infrared sensor rubbing alcohol
5
wipe away any
contamination from
the paper sensors