Operating Instructions - Magic Chef MCCHP12A Manual Del Usuario

OPERATING INSTRUCTIONS

CLEANING BEFORE USE
New units are wiped down at the factory to remove any visible signs of dirt, oil, grease, etc. remaining from the
manufacturing process. Before any food preparation, thoroughly wipe protective oil from all surface parts with
hot soapy water to remove any film residue and dust or debris.
NOTE: DO NOT use chlorine or sulfate/sulfide cleaners.
NOTE: Wash any accessories shipped with unit.
NOTE: Rinse accessories thoroughly.
NOTE: Wipe unit completely dry with a soft, clean cloth.
LIGHTING THE PILOT
1. Verify that the gas supply to the appliance matches
that listed on the label.
2. Make sure the control knobs are in the "OFF"
position.
3. Open the main gas supply valve.
4. Using a long match or grill lighter, light the pilots
located just to the rear of each burner (see
illustration).
WARNING: ALWAYS light the pilots immediately
after opening main gas supply valve.
5. Turn the burner control knobs counter-clockwise to
turn on and control the burners. 90° is fully open.
6. When finished, turn the control knobs clockwise to
the "OFF" position.
7. When done using, close the main gas supply valve.
NOTE: ALWAYS be sure to turn burners OFF when not
in use.
NOTE: There may be some smoke at the initial startup
as the result of rust prevention coatings burning off. This
is normal. Please allow at least a 15 minute burn in period
before using for the first time.
10
Figure 2
Pilots