Publicidad
Idiomas disponibles
Idiomas disponibles
I
DESCRIPTION
nalog TV modulator for video and audio Baseband,
G
to RF P L B/G signal. In the model stereo audio output
can be stereo or dual. The frequency range RF output is
between 47 and 862 MHz.
I
INST LL TION ND ST RT-UP
- The power sources must be disconnected from
the mains before connecting or disconnecting the
module.
Connect the earth connection of the frame to the earth
G
connection of the antenna installation.
Fix the modules to the frame in the order shown in the
G
application example (see page 3), with the power source
on the right and the amplifier on the left of the unit.
Connect the video and audio signal Baseband by the
G
connector minidDIN 5.
Join the RF channel outputs via the F-F coaxial bridge,
G
and load the free output of module 1 with 75 , beside
the power source.
Connect the Supply bus B 807 ref. 83807 between the
G
modules and the SPS.
Connect the power source to the mains.
G
I
UCF 300: BUTTON FUNCTIONS
J
J
The buttons
are for vertical menu scrolling.
L
M
G
a) On the programming menu they are for selecting the
function to be programmed.
b) parameter can be selected within a function.
c)
parameter setting can be modified within a
programmable parameter.
The
buttons are for horizontal scrolling through the
G
programming menu, e.g.:
Function
parameter
The
button is for moving right.
G
The
button is for exiting without changing the setting:
G
escape
The
button is for validating the data item programmed.
OK
G
I
UCF 300: DISPL Y INDIC TIONS
The UCF 300 control unit has two rows of alphanumerical
G
characters. The data display mode and programming
diagram on page 8 are a guide to this process:
If the characters are all upper case and on the upper
G
row, this indicates that one of the 4 functions has been
entered.
If data appear on two rows of the display, the
G
parameter to be adjusted is being displayed.
I
1. ST ND RD: Standard output signal.
1.1. Standard:
2. RF OUTPUT: RF output
2.1. Out Frequency:
2.2. Out Level:
2.3. Out RF:
3. VIDEO/ UDIO: Parameters associated with
video and audio signals.
3.1. Video Test:
3.2. Black Video:
3.3. udio Level:
value.
3.4. udio Mode:
3.5. udio Carrier Level:
10
The right arrow shows how to enter to change the
G
parameter setting.
flashing box indicates that the parameter setting
G
can be modified using the
(press the
button to validate).
OK
PROGR MMING with UCF 300
Connect the UCF 300 to the desired module. fter a
G
few seconds, the unit will show the model in question:
SM-ST 8000 or SM 8000.
Press the
button to enter the main programming
G
menu functions:
1. ST ND RD
2. RF OUTPUT
3. VIDEO / UDIO
4. MEMORY
J
J
Press the
button to scroll through the functions.
L
M
G
Press the
button to enter the parameters of the
G
desired function.
P L B/G.
47 ÷ 862 MHz.
.
65 ÷ 80 dBµV
Enables/disables the RF output.
YES/NO
YES/NO
0 ÷ 12
Estéreo / Dual B / Dual B .
(Only on the stereo units).
12 / 16 dBc.
J
J
L
M
Publicidad
