Cequent Towing Products 87421 Instrucciones De Instalación

Hitch Shown In Proper Position
Equipment Required: Metal file,
Pullwire (provided)
Fastener Kit: 75512F
Wrenches: 11/16
1
Drill Bits: None
2
Existing holes
to be modified
3
4
Note:
Fasteners typical
both sides.
1
Qty. (4) Carriage Bolt 7/16-14 X 1.25
2
Qty. (4) Spacer
1. Detach both (2) rear rubber muffler hangers to lower exhaust.
2. Enlarge either hole on bottom of both frame rails with a metal file enough to get spacer through.
3. Feed the pullwire through the newly enlarged hole, attach spacer and bolt and feed one at a time into the frame rail. Leave the
pullwire attached. Repeat on both frame rails as shown in Figure 3.
4. Feed the second spacer and bolt thru the enlarged hole and back out as shown in Figure 2. Leave the pullwire attached.
Repeat on both frame rails.
5. Feed the pullwires through the slot on the hitch brackets. Raise the hitch into position being careful not to push the fasteners
into the frame rails.
6. Attach remaining fasteners as shown Figure 1. Hand tighten only.
7. Check to assure hitch is centered on vehicle. Bracket may not fit snugly against side of frame rails. See Figure 4.
8. Tighten all fasteners to torque specifications.
9. Reattach rubber muffler hangers.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2006 Cequent Towing Products
Installation Instructions
Fascia
Exhaust hanger
Exhaust not
shown for clarity
Figure 1.
Tighten all 7/16 GR5 fasteners with torque wrench to 50 Lb.-Ft. (68 N*M)
Mazda CX-7
Do Not Exceed Lower of Towing Vehicle
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV3, SUV4
Figure 2.
Frame rail
3
Qty. (4) Conical Washer
4
Qty. (4) Nut 7/16-14
Sheet 1 of 3 75512N
Part Numbers:
Manufacturer's Rating or
Max Gross
Trailer WT (LB)
N/A
3500 (1589 Kg)
Enlarged hole
Kink pullwire to
Figure 3.
keep spacer
Example of
independent of bolt
pullwire procedure
Bracket may
not fit snugly
Exhaust hanger
Figure 4.
6-16-06
Form: F205 Rev A 5-6-05
75512
87421
44554
Max Tongue
WT (LB)
N/A
350 (159 Kg)
Frame rail
Rev. B