Cequent Towing Products 75560 Instrucciones De Instalación

Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75560F
Wrenches: 3/4, 14mm, 17mm
Drill Bits: None
Frame rail
See Figure 2 for Block Combinations
FASTENERS TYPICAL BOTH SIDES
1
Qty. (4) Bolt M10 X 1.25 X 40mm
2
Qty. (4) Conical Washer 3/8"
3
Qty. (1) Carriage Bolt 1/2"-13 X 1-3/4"
4
Qty. (1) Block (Large)
1. Remove the four muffler hangers (two per side) to allow the exhaust to hang down away from the frame.
2. On the wagon models, remove the forward most bolt (one per side) on the bracket that is bolted to the underside of the frame at the back of the
vehicle. Note: on the sedan and wagon you will need to remove the plastic plugs covering the weld nuts in the vehicle frame.
3. Raise hitch into position and loosely install the tow hook fasteners as shown above.
5. Block locations vary by vehicle model. Attach with block combination that fills gaps between hitch brackets and vehicle frame. Install fasteners
as shown in Figure 1.
6. Tighten 1/2-13 GR5 fasteners to 75 Lb.-Ft. (102 N*M). And tighten M10 CL8.8 fasteners to 38 Lb.-Ft. (52 N*M).
7. Reinstall (4) muffler hangers.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z 2007 Cequent Towing Products
Installation Instructions
SUBARU LEGACY SEDAN AND WAGON
SUBARU OUTBACK SEDAN AND WAGON
(Excluding Sport)
Trunk pan
Tow hook
Sheet 1 of 3
Do Not Exceed Lower of Towing Vehicle Manufacturer's Rating or
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Figure 1.
5
Qty. (1) Conical Washer 1/2"
6
Qty. (1) Hex Nut 1/2"-13
7
Qty. (4) Block (Small)
75560N
Part Numbers:
75560
44581
87446
Max Gross
Trailer WT (LB)
Not For Use With Spring Bars
4000 (1816 Kg) 400 (182 Kg)
Wiring Access Location: PC1, PC2
Existing weld nuts
(both sides)
Existing vehicle bracket
Double block at
Single block at
forward locations
forward locations
Single block at
Without blocks
all locations
Figure 2.
7-16-07
Form F206 Rev A 5605
Max Tongue
WT (LB)
Rev. A