6. MAINTENANCE TIME SCHEDULE TABLE
Structural Component
Solution
Ignition Plug
Check the condition. Adjust distance
and clean.
Replace if necessary.
Engine oil
Check the oil level.
Exchange oil.
Air filter
Clean or replace (if necessary).
Petrol filter
Clean petrol cock and the filter.
Replace if necessary.
Valves distance
Check and adjust with the engine
cooled down.
Fuel supply
Check the ptrol hopes for crack or
other damage; replace if necessary.
Exhaust
Check for holes, seal and replace if
necessary.
Check the silencer and clean or replace
if necessary.
Cold start
Check the choker function.
Cooling system
Check the cooling fan.
Screws and connecting
Check and replace if necessary.
elements.
7. WARRANTY
As shown in the warranty card attached.
8. FAULTS
If the machine fails to work perfectly, take the steps described below to clear the problem. If the trouble cannot be removed by your effort, turn to your dealer
for assistance.
Problem
Cause / Troubleshooting
Engine will not start.
1. Make sure that fuel cock and switch are in ON position.
2. Make sure that there is enough fuel in the tank.
3. Pull the starting cable more vigorously.
4. Make sure that the ignition plug is mounted correctly.
5. Make sure that the ignition plug cable is on the plug. Clean the ignition plug and check the electrodes
Run of engine is
1. Make sure that the ignition plug is mounted correctly. Make sure that the ignition plug cable is on the plug.
uneven.
2. Make sure that the fuel you are using is correct.
Generator does not
1. If the indicating light is not on, you cannot fix the failure yourselves.
generate any current
If the indicating light is on:
2. Press the respective button to reset the output applied.
3. Check the connection.
4. Check the unit for possible short circuit or overloading.
for correct distance.
Clean the ignition plug and check the electrodes for correct distance.
Every day
Month 1
X
X
X
X
X
24
Month 3
Month 6
X
X
X
X
X
X
X
Month 12
X
X