Handwheel Assembly - Craftsman professional 152.221240 Manual Del Operador

POLY-V BELT ASSEMBLY
WARNING
MAKE CERTAIN the table saw is disconnected from
the power source.
Figure 6-1
1. Make sure all packaging material has been
removed from inside the cabinet.
2. Open the motor cover and place the motor Poly-V
belt (A) over the blade pulley (B). See figure 6-1.
3. Carefully lift the motor (C) and place the belt under
the motor pulley (not shown). Make sure all the
v-notches in the belt are mated with the v-notches
of the blade and motor pulley. See figure 6-1.
4. Carefully let the motor down and close motor cover.
EXTENSION WING ASSEMBLY
WARNING
MAKE CERTAIN the table saw is disconnected from
the power source.
WARNING
The right extension wing must be completely assem-
bled and motor cover closed and fastened before table
saw is to be connected to the power source.
Figure 7-1
A
B
B
A
C
B
1. CAUTION: The extension wings are heavy; two
people are required to assemble both extension
wings to the table saw.
2. Assemble one of the extension wings (A) to the left
side of the table saw. Align the four holes (B) in the
extension wing with the four holes in the left side of
the saw table. Use four M8 x 30mm hex head
screws, M8 lock washers and M8 flat washers. Do
not completely tighten hardware at this time. See
figure 7-1.
Figure 7-2
G
3. Lay a straight edge (C) across the saw table (D)
and extension wing (E). Make sure that the front
face of the extension wing (F) is flat to the front
face of the saw table (G). Adjust the extension
wing so that its top surface is exactly flat to the saw
table and securely tighten hardware. See figure 7-2.
4. Repeat steps 2 and 3 above to assemble the other
extension wing to the right side of the table saw.

HANDWHEEL ASSEMBLY

WARNING
MAKE CERTAIN the table saw is disconnected from
the power source.
Figure 8-1
A
17
D
E
C
F
D
C
B