Revell Control BEASTIE BUG Manual Del Usuario página 4

Steering Trim:
• If the vehicle pulls right (when viewed from
behind), push the left  trim button.
• If the vehicle pulls left (when viewed from
behind), push the right trim button.
Driving Tips:
• If the controller sits idle (without input) for 2 minutes, it will go into Power Save Mode. The LED will begin fl ashing slowly. After 9
minutes without input, the controller will shut off.
• Run the vehicle on a fl at surface.
• Watch the vehicle instead of looking at the controller.
• Always release the throttle trigger right away following a crash to prevent damaging the electronics.
• The vehicle should be operated in an area that has as much open space as possible with no people or animals nearby.
• Do not operate this vehicle on the street.
Binding Procedure
To bind the controller to the receiver:
1. Hold the right trim button on the controller and turn on the controller. The LED on the controller will blink.
2. Turn on the receiver. The LED on the controller will turn solid.
3. Process is complete.
Troubleshooting
Problem: The wheels won't turn.
Solution: Recharge the battery.
Problem: The controller doesn't function.
Solution: Make sure the batteries are inserted correctly.
Insert new batteries.
Problem: The vehicle loses speed or comes to a stop.
Solution: Recharge the battery.
Problem: Controller LED fl ashing slowly (low voltage).
Solution: Replace the controller batteries.
© 2013 REVELL INC. A SUBSIDIARY OF HOBBICO, INC.
REVELL, INC. 1850 HOWARD ST., UNIT A, ELK GROVE VILLAGE, IL 60007 U.S.A.
MADE IN SHANGHAI, CHINA
PLEASE RETAIN PACKAGING FOR FUTURE REFERENCE. CONTENTS AND
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
4
Driving the Vehicle (continued)
Steering Trim Buttons
Service
If your Beastie Bug ™ requires repairs or replacement,
DO NOT RETURN TO RETAILER. Contact:
Hobby Services
3002 N. Apollo Drive, Suite 1
Champaign, Il, 61822, U.S.A.
9am-5pm Central Mon.-Fri.
(217) 398-0007
hobbyservices@hobbico.com
revell.com