memorex MPH 6928 Manual De Instrucciones página 28

Color profile: Disabled
Composite Default screen
HINT
You may use the < and >
keys to toggle between
numbers when programming
the area code.
NOTE
If you have no New Caller ID
Messages, then the "New"
display is blank. Only the
"Total" display appears.
NOTE
Once a Caller ID message
has been viewed, it is no
longer considered a
new message.
C:...MPH6928 VA OM.vp
Mon Feb 14 15:27:45 2000
To change your Caller ID options:
1) Press and hold
CALLER
seconds. The following screen appears.
2) Use the : and ; keys to move the cursor to the selection that you
would like to change. Press the
for and
Off Autotalk
keypad to enter or change the area code, then press
a confirmation tone indicating the area code has been changed.)
3) After you have made your selections, press
handset to the base. The
setup changes are now effective.
Screening Your Calls
M
Caller ID allows you to review caller
information before you answer your
phone. When the phone rings, the
display shows the date, time, name, and
phone number of the caller. If your Caller ID
service is number only, then the name does
not appear on the second line.
If a name or number is not available, the display will show a
message such as
Incomplete Data
, etc.
Private Name
Using CIDCW (Caller ID on Call Waiting)
M
1) During a call when you hear the
Caller Waiting tone, check the handset
for the name and number of the
incoming caller.
2) Press FLASH to accept the incoming call. See page 22 for
additional information.
ID for two
1 > Auto Talk:Off
2 CIDCW
3 Area Code:
key to toggle between
SELECT
. Press and use the number
CIDCW
SELECT
SELECT
CALLER
LED flashes, indicating that your
STATUS
12/21 12:30PM
Schlitz Kaysie
305-555-1212
,
Private Number
Talk
Schlitz Kaysie
305-555-1212
:On
and
On
again. (You hear
ID and return the
,
0:00
27