FSC metro makro GDF3004GDF3008 Manual De Instrucciones página 17

INSTALLATION
Model GDF3004 and GDF3024
• Place the oil reservoir into the housing (fig. 1).
• Insert the metal piece of the control unit into the
gap between the support plate and back of the
housing (fig. 2).
• Make sure that the two poles of the control
unit properly go through the two holes on the
support plate.
• Ensure that the heating elements are securely
in place in the oil reservoirs.
1
To assemble the basket handle onto the frying
basket:
• Press the two wire bars slightly inwards. Insert
the two ends of the wire bars into the two loops
of the frying basket (fig. 3).
• Press the basket handle over the clip of the
basket until it locks into place (fig. 4).
• Warning! Do not attach the basket handle
in any other way to the frying basket. Other
installation method could cause injury.
• Check if the basket handle is attached to the
frying basket properly (fig. 4).
3
Loops
2
Metal
piece
Pole
Gap
Support plate
Model GDF3004 and GDF3024
4
Clip
Model GDF3008 and GDF3028
• Insert the locating sheet into the gap between
housing and supporter and make sure that the
control unit is firmly placed on the housing.
• Ensure that the heating elements are securely
in place in the oil reservoirs.
5
Model GDF5008 and GDF5028
• Align the pole on the bottom of the control unit
to the hole on the top of the housing.
• Insert the pole into the hole and make sure that
the control unit is firmly placed on the housing.
• Ensure that the heating elements are securely
in place in the oil reservoirs.
5
Hole
- 16 -
Locating sheet
The gap between
housing and
supporter
Pole
GB