Cleaning And Maintenance - FSC metro makro GDF3004GDF3008 Manual De Instrucciones

Model GDF3024, GDF3028 and GDF5028
The fixers need to be installed for Model GDF3024,
GDF3028 and GDF5028.
Note: When installing these three types of fryer
models, fix the fryer housing to a flat surface
GB
before installing the control unit (fig. 5).
• Remove both rubber feet that are on the bottom
rear part of the fryer.
• Put the fixers on. Reinstall the rubber feet.
• Fix the rubber feet and fixers onto the bottom of
the fryer by using a screw.
• Firmly fix the fryer on a desired flat surface by
tightening the screws (not included) through the
hole of the fixers.
Fixer
OPERATION
1. Temperature control knob
2. Working indicator
3. Power indicator
WARNINGS!
– Before filling with oil, make sure there is no water
remaining in the oil reservoir. Wipe off oil spills on
the outer surface of the deep fryer.
– Never fill with oil or fat over the MAX or under the
MIN marking in the oil reservoir.
– Make sure the temperature control knob is set
to (off) before connecting the appliance to the
electrical outlet.
– Never switch on the deep fryer without oil or fat in
the oil reservoir.
Rubber foot
Hole
• Fill oil into the dry and empty oil reservoir only
( Choosing the oil).
• Prepare the food for frying.
• Connect the power plug to a suitable electrical
outlet. The power indicator lights up green.
• Place the lid onto the oil reservoir.
• Switch on the deep fryer by turning the
temperature control knob to the desired
temperature. The working indicator lights up
orange.
• When the oil temperature reaches the set value,
the appliance switches off automatically. The
working indicator goes off. This keeps the oil
temperature constantly at the set value. Do not
overfill the frying basket.
• Remove the lid.
• Now the appliance is ready for frying food.
• When food is ready then carefully lift out the frying
basket. Hang it onto the bar of the control unit by
using the basket hook.
• Allow a few moments for excess oil to drip off.
• After the frying process is finished, set the
temperature control knob to
• Disconnect the power plug from the electrical
outlet. The power indicator goes off.
FAT TO BE USED
• Oils suitable for frying as tempered oils and fats,
pure corn oil, soybean, sunflower oil.
SOLID FAT
• Solid fat can be used as an alternative to oil but
needs to be fully melted before frying.
6. Cleaning and maintenance
CLEANING
• Disconnect the power plug from the electrical
outlet. Allow all parts of the appliance and the oil
or fat to cool completely.
• Remove the lid, frying basket and the heating
element cover.
• Lift the control unit to remove it from the oil
reservoir and housing.
For model GDF3004/GDF3024
• Take the oil reservoir out of the housing.
• Pour the oil or fat out from the oil reservoir
( Disposal of used oil and fat).
- 17 -
(off) position.