Maintenance - Greenlee H8508 Serie Operación Manual

Operation (cont'd)
1. Start the power source.
Note: Allow the power source to run for a few
minutes to warm the hydraulic fluid.
2. Set the directional spool to the appropriate position
(forward or reverse).
Do not change the position of the directional spool
while the tool is operating. Allow the tool to stop
before changing direction.
Failure to observe this precaution can result in
property damage.
3. Grasp the handle. Place your other hand on the top
of the tool or on the auxiliary handle. This will allow
you to apply leverage while operating the tool.
4. To start the tool, squeeze the trigger.
• Variable torque models only: Use the variable
torque adjustment to achieve the necessary amount
of torque. Turn the variable torque output screw
counterclockwise to increase torque, or clockwise
to decrease the torque.
• All models: If 5 seconds of impacting does
not loosen a bolt, nut, etc., stop impacting and
use some other method of removal. Continued
impacting will cause severe wear on the impact
mechanism.
5. To stop the tool, release the trigger.
6. When the tool is not in use, stop the power source
to reduce heat and wear on tool components.
Greenlee Tools, Inc.
H8508 Series Impact Wrenches

Maintenance

Wear eye protection when operating or
servicing this tool.
Failure to wear eye protection could
result in serious eye injury from flying
debris or hydraulic oil.
Do not change accessories, inspect, or clean tool when it
is connected to a power source. Accidental start-up can
result in serious injury.
Failure to observe this warning could result in severe
injury or death.
Use this maintenance schedule to maximize the tool's
service life.
Note:
• Keep all decals clean and legible, and replace when
necessary.
• When disposing of any components (hydraulic hoses,
hydraulic fluid, worn parts, etc.), do so in accordance
with federal, state, and local laws or ordinances.
Daily
1. Wipe all tool surfaces clean.
2. Inspect the hydraulic hoses and fittings for signs of
leaks, cracks, wear, or damage. Replace if necessary.
3. Install dust caps over the hydraulic ports when the
tool is disconnected.
Monthly
Perform a thorough inspection of the hydraulic hoses
and fittings as described in publication 99930323,
SAE J1273 (Hose and Hose Assemblies).
10
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070