ASROCK K10N78-1394 Manual De Instalación página 33

12 24
13
1
4 8
1 5
HDMI_SPDIF Cable
C
(Optional)
A. black end B. white end (2-pin)
2.10 eSAT T T T T AII Inter 2.10 eSA 2.10 eSA 2.10 eSA 2.10 eSA AII Inter AII Inter AII Inter AII Interface Introduction (Only for K10N78-1394) face Introduction (Only for K10N78-1394) face Introduction (Only for K10N78-1394) face Introduction (Only for K10N78-1394) face Introduction (Only for K10N78-1394)
NOTE:
1. If you set "SATA Operation Mode" option in BIOS setup to AHCI or RAID mode, Hot
Plug function is supported with eSATAII devices. Therefore, you can insert or remove
your eSATAII devices to the eSATAII ports while the system is power-on and in
working condition.
2. If you set "SATA Operation Mode" option in BIOS setup to IDE mode, Hot Plug
function is not supported with eSATAII devices. If you still want to use eSATAII
function in IDE mode, please insert or remove your eSATAII devices to the
eSATAII ports only when the system is power-off.
3. If you want to use the eSATAII HDD as an OS disk, please set "SATA Operation
Mode" option in BIOS setup to IDE mode. If you want to use the eSATAII HDD
as a removable data disk, please set "SATA Operation Mode" option in BIOS setup
to RAID mode. If you want to add the eSATAII HDD as a RAID disk, please set "SATA
Operation Mode" option in BIOS setup to RAID mode.
4. Please do not configure your eSATAII HDD as a RAID disk; otherwise, it may affect
the Hot Plug function that eSATAII HDD should have.
5. Please refer to page 34 to 36 for detailed information of RAID mode, IDE mode and
AHCI mode.
How to install eSATAII?
SATAII_6 (PORT5)
ASRock K10N78-1394 / K10N78
Please connect the black end (A)
of HDMI_SPDIF cable to the
B
HDMI_SPDIF header on the
A
motherboard. Then connect the
white end (B or C) of
HDMI_SPDIF cable to the
HDMI_SPDIF connector of HDMI
VGA card.
C. white end (3-pin)
eSATAII_TOP
Motherboard
3 3 3 3
3 3 3 3 3 3