Programming Mode; Setting Custom Scales - Calculated Industries Scale Master Classic 6020 Guia Del Usuario

Programming Mode

The Scale Master Classic allows you to preset
frequently used values, including:
• Custom Scales (3 U.S./3 Metric)
Height value
•
The following keys are used in programming mode:
[M1+]
[SUBTRACT/COUnT]
selected digit/units.
[SCALE]
place to the right. Exits and saves changes if
pressed while right-most digit is selected.
[MODE]
place to the left.
[RESET]

Setting Custom Scales

You can program and store six Custom Scales:
three in U.S. mode and three in Metric mode.
You can set a custom scale two ways: by "rolling in"
a known distance or by entering the exact distance.
Rolling a Custom Scale
1) Press
[MODE]
number 1-3) appears in the scale box display.
2) Press
[SUBTRACT/COUnT]
" " will appear in the main display.
roll
3) Roll desired distance. "
appears in the main display.
Note: For greater accuracy, roll the longest known
distance you have on your plan.
4) Press
[SCALE]
Increases the selected digit/units.
Advances the cursor to the next
Moves the cursor back to the next
Exits without saving.
until
. The annunciator will begin
Decreases the
(# being a
#
open
+
rolling
[SCALE]
" now
(Cont'd)
9 – User's Guide
.