Troubleshooting Guide; Technical Service - Zenith Heath SL-5309 Manual Del Usuario

SYMPTOM POSSIBLE CAUSE
Light will not come 1. Light switch is turned off.
on. 2. Halogen lamp is loose or burned
3. Fuse is blown or circuit breaker
4. Daylight turn-off is in effect.
5. Incorrect circuit wiring, if this is
6. Not aimed correctly. (Re-aim the
Light comes on in
1. Light control may be installed in
daylight.
2. Light control is in TEST. (Select 1,
Light comes on for
1. Light control's sensor may be
no apparent reason.
2. Sensitivity is set too high. (Re-
Please call 1-800-858-8501 (English speaking only) for assistance before returning
If you experience a problem, follow this guide. You may also want to visit our Web site at: www.hzsupport.com.
If the problem persists, call* for assistance at 1-800-858-8501 (English speaking only), 7:30 AM to 4:30 PM CST
(M-F). You may also write* to:
HeathCo LLC
P.O. Box 90004, Bowling Green, KY 42102-9004
ATTN: Technical Service
* If contacting Technical Service, please have the following information available: Model Number, Date of Pur-
chase, and Place of Purchase.
This is a "Limited Warranty" which gives you specific legal rights. You may also have other rights which vary from state to state or province
to province.
For a period of one year from the date of purchase, any malfunction caused by factory defective parts or workmanship will be corrected
at no charge to you.
Not Covered - Repair service, adjustment and calibration due to misuse, abuse or negligence, light bulbs, batteries, and other expend-
able items are not covered by this warranty. Unauthorized service or modification of the product or of any furnished component will
void this warranty in its entirety. This warranty does not include reimbursement for inconvenience, installation, setup time, loss of use,
unauthorized service, or return shipping charges.
This warranty covers only HeathCo LLC assembled products and is not extended to other equipment and components that a customer
uses in conjunction with our products.
THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTY,
REPRESENTATION OR CONDITION OF MERCHANT ABILITY OR THAT THE PRODUCTS ARE FIT FOR ANY PARTICULAR PUR-
POSE OR USE, AND SPECIFICALLY IN LIEU OF ALL SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES.
REPAIR OR REPLACEMENT SHALL BE THE SOLE REMEDY OF THE CUSTOMER AND THERE SHALL BE NO LIABILITY ON THE
PART OF HEATHCO LLC FOR ANY SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT
LIMITED TO ANY LOSS OF BUSINESS OR PROFITS, WHETHER OR NOT FORESEEABLE. Some states or provinces do not allow
the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. Please
keep your dated sales receipt, it is required for all warranty requests.

TROUBLESHOOTING GUIDE

out.
is turned off.
(Recheck after dark.)
a new installation.
sensor to cover desired area.)
a relatively dark location.
5 or 10 minutes for AUTO time.)
detecting small animals, sway-
ing trees, or automobile traffic.
(Re-aim sensor.)
duce sensitivity.)

TECHNICAL SERvICE

product to store.
No Service Parts Available for this Product
ONE YEAR LIMITED WARRANTY
SYMPTOM POSSIBLE CAUSE
Light stays on 1. The halogen lamp is positioned too
continuously.
2. Light control's sensor is pointed
3. LIght control is in Manual Mode.
Light flashes on 1. Heat or light from the halogen lamp
and off.
2. Heat being reflected from other
3. Light control is in the TEST mode
4
close to the light control's sensor
or pointed at nearby objects that
cause heat to trigger the sensor.
(Reposition the lamp away from
the sensor or nearby objects.)
toward a heat source like an air
vent, dryer vent, or brightly-painted
heat-reflective surface. (Reposition
sensor.)
(Switch to Auto.)
may be turning the light control on
and off. (Reposition the lamp away
from the sensor.)
objects may be affecting the light
control. (Re-aim sensor).
and warming up. (Flashing is normal
under these conditions.)
595-5496-07