Safety And General Information; Product Description - Omega Lift Equipment 34100 Manual De Piezas E Instrucciones De Funcionamiento

Soporte/gato neumático de 10 toneladas (20 000 libras)
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

• Study, understand, and follow all instructions before operating this device.
• Do not exceed rated capacity.
• Use only on hard, level surfaces.
• Lifting device only. Immediately after lifting, support the vehicle with appropriate means.
• Do not move or dolly loads with this device.
• Lift only on areas of the vehicle as specified by the vehicle manufacturer.
• No alterations shall be made to this product.
• Failure to heed these markings may result in personal injury and/or property damage.

SAFETY AND GENERAL INFORMATION

Save these instructions. For your safety read, understand, and follow the information provided with and on this jack.
The owner and operator of this equipment shall have an understanding of this jack and safe operating procedures before
attempting to use. The owner and operator shall be aware that use and repair of this product may require special skills
and knowledge. Instructions and safety information shall be conveyed in the operator's native language before use of this
jack is authorized. If any doubt exists as to the safe and proper use of this jack, remove from service immediately.
Inspect before each use. Do not use if broken, bent, cracked, or damaged parts (including labels) are noted. Any jack
that appears damaged in any way, operates abnormally or is missing parts, shall be removed from service immediately
and the manufacturer notified. If you suspect that the jack was subjected to a shock load (a load dropped suddenly,
unexpectedly upon it), immediately discontinue use until the jack has been checked by a factory authorized service
center (contact distributor or manufacturer for list of Authorized Service Centers). It is recommended that an annual
inspection be done by qualified personnel. Replace worn or damaged parts with Omega Authorized Replacement Parts
only. Labels and owner's manuals are available from manufacturer.

PRODUCT DESCRIPTION

The Omega 10 Ton Air Jack/Support Stand is designed to lift and support rated capacity loads. Intended use: To lift
one wheel or one axle of a vehicle for the purpose of service and/or repair of vehicle components. Use this jack in
pairs when lifting an entire end of a vehicle. Check with vehicle owner's manual for proper lift points. Use one pair per
vehicle.
WARNING: Rated capacity of this device is a reference to the working load this stand is is capable of sustaining.
!
Rated capacity is not increased when jacks are used in mutiples.
!
WARNING: Do not use for any purpose other than those uses outlined in this manual. DO NOT use jack around
corrosive materials such as chlorides - commonly used by road crews to melt snow and ice. Water and slush from
vehicles exposed to chlorides may enter jack cylinder, severely and permanently damaging interior of cylinder
and causing air leaks which adversely affect lifting performance.
SPECIFICATIONS
Model
Capacity
34100
10 Ton
WARNING
!
Starting
Max. Lift
Height
Height
17-1/2" to 40"
51-1/8"
Power
Jack Size
Travel
( L x W x H )
11-1/2"
22" x 12" x 17"
2
Rated Capacity
Air Pressure
200 psi

Publicidad

Tabla de contenido
loading

Tabla de contenido