Farfisa ZH1262PLB Manual Del Usuario página 25

SET-UP MENU DIAGRAM
Settings - This menu is reserved exclusively to qualified staff; therefore, it is protected by password; to
access the menu follow the indications given in the main menu at page 35.
Intercommunicating - Here the user can enter the names and addresses of intercommunication devices
or to modify the data stored previously; to manage these parameters, the user must know the user and
room addresses (if required).
Entrances - Here the user can enter the names and addresses of external door stations or to modify the
data stored previously; to manage these parameters, the user must know the addresses of door stations.
A tua io c t ns - Here the user can enter the names and addresses of actuators or to modify the data stored
previously; to manage these parameters, the user must know the addresses of actuators.
Installation wizard - This procedure enables simple setup of parameters that are essential for the
operation of the device. The procedure is enabled automatically at first power-ON or it can be run later
via this menu.
Favourite buttons - In this menu the user can assign direct functions to any of the 6 keys located to the
side of the screen; direct functions are assigned through factory setting only to the 2 keys on bottom
right (second door opening) and left (silent).
System - Here the user can set the specific parameters of the system.
User address - This is the address that enables the video intercom to receive the call coming
from external door stations from door keeper exchangers or other internal intercommunicating
stations. For further information refer to chapter "Programming".
Room - This is the address that enables identifying the intercommunicating devices installed in
the same apartment; therefore, devices that have the same user address, but installed in
different rooms. For further information refer to chapter "Programming".
Supplementary addresses - The additional addresses (maximum 10) are further addresses to
which the device should answer beside its own.
Forwarding A1 - Enables or disables redialing floor call (doorbell) to other devices installed in
the same apartment or running advanced functions.
Back - Return to previous page.
Default - It enables resetting the factory settings of the device; if there are any intercommunicating
devices, external door stations and actuators programmed, such entries will not be deleted.
Advanced - Procedures and information protected by password that can only be accesses by Aci Farfisa
technical service.
Show settings - List of all actual settings.
Back - Return to previous page.
Intercommunicating Installation Installation
wizard wizard
Entrances Favourite Favourite
buttons buttons
Actuations Back
Use the keys or turn the wheel sensor to change the page when
on middle bottom page appear 2 or more boxes.
Set-up Menu
(first and second page)
System
Default
Advanced
Show Show
settings settings
Back
- 35 -
System Menu
Address Forwarding Forwarding
A1 A1
Room
Supplementary Supplementary Back
addresses addresses
Mi 2479