Glacier bay SIL16-BM Guía De Uso Y Cuidado

TOOLS REQUIRED
Claw hammer
Measuring tape
Installation
1
DETERMINING THE MOUNTING LOCATION
NOTE: Before installing, make sure all parts are
present. Compare parts with the Hardware Included
list. If any part is missing or damaged, do not attempt
to install the product.
□ Determine the desired mounting location, and mark
the wall where the unit will be installed.
3
INSTALLING THE CABINET
□ For wall stud installation, insert #12 x 3 in. screws
with washers into the stud locations (not included).
□ For drywall installation, drill holes at the appropriate
locations and insert toggle bolts with washers (not
included).
□ For concrete wall installation, drill 1/4 in. holes at the
appropriate locations and insert #12 wall anchors,
followed by #12 x 3 in. screws (not included).
Safety goggles Phillips screwdriver
Wall hardware
Use and Care Guide
Lighted Medicine Cabinet
Power drill
Level
2
PRE-DRILLING THE BACK OF THE CABINET
□ Drill 1/8 in. diameter holes through the back
panel of the cabinet
4
CONNECTING THE ELECTRICAL WIRING
CAUTION: Turn off electrical power by either removing the fuse or
shutting off the circuit breaker prior to installing the fixture. Use G25,
40W maximum standard base bulbs, sold separately.
□ Do not try to remove the mirrored face-plate as it is
permanently attached.
□ Connect house wires to lightbar wires using standard wire
connectors as per local code. Make sure that fixture is grounded
with brass wire to assure proper electrical connection.
□ Install G25, 40W maximum light bulbs (not included).
□ Socket cups (CC) fit over the light socket.
CC
Item #1000 004 907
Model #SIL16-BM
HARDWARE INCLUDED
AA - Shelf
x 2
CC - Socket Cups x 3
BLACK WHITE
Please contact 1-888-774-8062 for further assistance.
BB - Shelf Clip
x 8
UNINSULATED
BRASS (GROUND)
HOMEDEPOT.COM