Warranty - Altrad Belle RPC 60/80 Manual Del Operador

Assembly of the Control Pump
1. Carefully clean the housing with compressed air on the inside. Check for scratches on sliding bores for O Rings and there are
no sharp edges.
2. Press the Bushing in to Housing.
in the right position. When the Lip Seal is in the Groove this represents forward motion.
CAUTION
to Reverse. (See CAUTION
7. Lubricate the Pinion and O Rings with hydraulic oil and carefully insert in to the Housing. Make sure the Rack is in the right
position and this is easiest when in reverse motion.
10. Assemble the Hydraulic Connector and Dowty Washer using LOCTITE 243.
original date of purchase.
operation or user maintenance instructions.
The following components are not covered by warranty.
• Drivebelt/s
• Engine Air Filter
• Engine Spark Plug
losses or expenses in connection with or by reason of or the inability to use the machine for any purpose.
Warranty Claims
For warranty claims:
or Write to:
Derbyshire
SK17 0EU
England
Warranty Registration:
http://www.bellegroup.com/index.php?p=warranty_registration
the registration page.
Service & Maintenance
In reverse motion the Control Handles run parallel with the Housing in the direction of the operator.
DO NOT TIGHTEN.
LOCTITE seal 518 is recommended.
LOCTITE 243.

Warranty

25