Cleaning And Maintenance - Famastil F-POWER P2111.120 Manual De Instrucciones

If taking a break of five minutes or more:
Engage gun safety lock.
01
02 Unplug the power cord from the outlet.
03 Turn unit to "OFF" (O) position.
CAUTION! Failure to clean properly will cause the detergent
injection system to become clogged and inoperable.
• Bleach, chlorine products and other corrosive chemicals
• Liquids containing solvents (i.e., paint thinners, gasoline, oils)
These chemicals will harm the unit and will damage the surface being cleaned.

CLEANING AND MAINTENANCE

CONNECTIONS
Connections on pressure washer hoses; gun and spray wand should be cleaned
regularly and lubricated with non-water soluble grease.
SPRAY TIPS ONLY
Clogging of the spray tips causes the pump pressure to be too high and cleaning is
immediately required. You can clean the spray tips by carefully inserting the needle,
or a thin, sharp instrument (i.e. paperclip) into the tip to rid it of deposits.
WATER FILTER SCREEN
The pressure washer is equipped with a water inlet screen to protect the pump. If the
screen is not kept clean, the flow of water to the pressure washer will be restricted
and the pump may be damaged.
To clean inner water screen, remove quick-connector and remove the filter
01
screen from the pump inlet.
Rinse screen until it is free of debris and blockage.
02
Replace screen and quick-connector immediately to prevent any foreign matter
03
from entering the pump.
TAKING A BREAK
CAUTION! Never use:
• Tri-sodium phosphate products
• Ammonia products
• Acid-based products
33