Famastil F-POWER P2111.120 Manual De Instrucciones página 34

When storing your High Pressure Washer, a few simple steps are essential for
maintaining a longer life of the product.
• Always store it in a place protected from sun and moisture.
• Never bend the hose, just wrap it for storage.
• Do not put any weight on the hose or fittings, and try to store them always clean,
because wet dirty may dry causing the clogging of accessories.
FAQ (FREQUENTLY ASKED QUESTIONS)
1. The washer turns on and off, even if you keep the trigger pressed;
If you notice that the washer is the motor turning on and off even when you hold
the trigger down, make sure all the false air contained in the hose was released, this
may cause malfunction of the pump. Also check if there is any leak in your washer.
No matter how small the leakage of water is, this may cause erratic in the washer.
Check sites such as the washing water inlet, the outlet of the high pressure hose and
accessories (gun and lances).
Another factor that may cause this symptom is the insufficient intake of water in
the pump. Make sure the tap is open enough.
2. The washer seems clogged, no water outlet.
If when you press the trigger to realize that the engine will not turn on automati-
cally, your washer may be clogged, and the blockage usually occurs in front lance of
the washer. If so, you can use the unclog needle that is attached to this manual.
Powder detergents and water impurities are usually the causes of clogging the
machine.
3. There is a leak in one of the lances/gun, I can continue to use the washing
machine?
If you notice any leakage at some of the accessories of the hose where water con-
tinues running even when the washer is locked with the trigger, immediately replace
the defective accessory, because it may damage some internal components of your
washer.
If you cannot solve the problem, take this product for the nearest Famastil F-Power
technical assistance workshop.
34
STORAGE