Electrolux EFB60680BX Manual De Uso página 5

ControLs
Button Function
a Decreases the working speed or exits timed intensive speed. The number of lighted LeDs decreases.
Touch and hold the button for 5 seconds to activate/deacti-
vate the Remote control receiver.
B Turns the motor on/off and displays the speed bar.
C increases the working speed.
continuing to touch the button to activate intensive speed,
which is timed to run for 10 minutes.at the end of the 10
minutes intensive speed will automatically drop to the level
below and the last LED will go out.
D Decreases the lighting intensity.
E Turns the lighting system off/on at maximum intensity.
Touch and hold for 5 seconds to enable/disable the
activated charcoal Filters alarm.
F increases the lighting intensity
G With the filter alarm active, press the button to Reset the
alarm itself. These indications are only visible when the
motor is turned off.
H activates/Deactivates the sensor.
When the Hood is switched off, none of the functions is displayed, and only the normal lettering on the control panel is visible.every time
the hood is connected to the power supply the system activates calibration of the odour sensor. This calibration is indi-cated by the fact that
button H flashes once a second. by default the system is set up for an electric hob, but during calibration it is possible to select the hob type.
press and hold for 5 seconds button H -> Gas Hob, the Speed LeD bar will flash twice. (calibration lasts 1 minute).
press and hold for 5 seconds button H -> electric Hob, the Speed LeD bar will flash 4 times. (calibration lasts 13 minutes).
it is possible to change the type of hob and recalibrate the sensor at a later date, simply by pressing and holding button H for approximately
5 seconds. This reactivates calibration of the sensor.
LiGHtinG
Warning: This appliance is fitted with a
white LeD lamp classed as 1m according
to En 60825-1: 1994 + A1:2002 + A2:2001
standards; maximum optical power emitted
@439nm: 7µW. Do not look directly at the light
through optical devices (binoculars, magnifying
glasses...).
• For replacement contact technical support.
("To purchase contact technical support").
www.markabolt.hu
Display
1 Flash of button a+C indicates that the Remote control
receiver is activated
2 Flashes of button a+C indicate that the Remote control
receiver is Deactivated
the LEDs for the set speed light up.
The number of lighted LeDs increases.
LeD bar fully on -> intensive speed activated
-
-
Flash from button C indicates that the activated charcoal
Filters alarm is activated
Flash from button a indicates that the activated charcoal
Filters alarm is deactivated
-
When the procedure termi n ates, the i n di c ati o n shown previ o usl y turns off:
Button lit indicates the need to wash the metal grease filters. The
alarm is triggered after the Hood has been in operation for 100 working
hours.
Button Flashing indicates the need to change the activated charcoal
filters, and also to wash the metal grease filters. the alarm is triggered
after the Hood has been in operation for 200 working hours.
When it is activated, the luminosity of the button changes from
50% to 100% intensity.
When it is deactivated, the luminosity of the button changes
from 100% to 50% intensity.
english
5