Taking-Out And Installation Of The Lower Freezer Drawer - Telstar TRX596310MD Manual De Instrucciones

• Taking-out and installation of the lower freezer drawer

1. Pull out the lower freezer drawer first.
2. Take out the two fixed screws from the partition plate of the lower freezer drawer with screw driver and
then take off the partition plate.
3. Take off the rear stopper for the lower drawer as shown by Fig. A.
4. Take out the lower drawer body with force as directed by the arrows in Fig. B.
5. The installation of the lower drawer body is conducted in the reverse order. You should install the lower
drawer body first and then install the rear stopper for the lower drawer as shown in Fig. C. Finally, both
sides of the drawer shall be connected to the position shown by the arrows respectively.
6. The partition plate is installed into the corresponding slots and then is fixed with screws. The position of
the partition plate for the lower drawer could be adjusted according to your preference.
Don't remove the lower freezer drawer if not necessary.
34
Automatic Refrigerator
TRX596310MD