Important Safety Instructions - James TVJ LED 39 F3300F Manual De Funcionamiento

IMPORTANT SAFETY INSTRUCTIONS

1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any of the ventilation openings.
install in accordance with the manufacturer's
instructions.
8. Do not install near any heat sources such as
radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized
or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding
type plug has two blades and a third groundingprong.
The wide blade or third prong are provided for your
safety. When the provided plug does not fit into your
outlet, consult anelectrician for replacement of the
obsolete outlet.
10.Protect the power cord from being walked on or
pinched, particularly at plugs, convenience re
-ceptacles, and the point where they exit from the
apparatus.
11.Only use attachments/accessories specified by
the manufacturer.
12.Use only with a cart, stand, tripod, bracket, or
table specified by the manufacturer or
sold with the apparatus. When a cart is
used, use caution when moving the
cart/apparatus combination to avoid
injury from tip-over.
13.Unplug this apparatus during lightning storms
or when unused for long periods of time.
14.Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has
been damaged in any way, such as if the power
-supply cord or plug is damaged, liquid has been
spilled or objects have fallen into the apparatus,
or if the apparatus has been exposed to rain or
moisture, does not operate normally, or has been
dropped.
15.This product may contain lead and mercury.
Disposal of these materials may be regulated due
to environmental considerations. For disposal or
recycling information, please contact your local
authorities or the Electronic Industries Alliance
(www.eiae.org).
16.Damage Requiring Service - The appliance
should be serviced by qualified service personnel
when:
A. The power supply cord or the plug has been
damaged;
B. Objects have fallen or liquid has been spilled
into the appliance;
Read before operating equipment
C.The appliance has been exposed to rain;
D. The appliance does not appear to operate
normally or exhibits a marked change in
performance;
E.The appliance has been dropped or the
enclosure damaged.
17. Tilt/Stability - All televisions must comply with
recommended international global safety
standards for tilt and stability properties of its
cabinet design.
Do not compromise these design standards by
applying excessive pull force to the front, or top,
of the cabinet, which could ultimately overturn
•
the product.
Also, do not endanger yourself, or children, by
•
placing electronic equipment/toys on th e top
Of the cabinet. Such items could unsuspectingly
fall from the top of the set and cause damage
and/or personal injury.
18.Wall or Ceiling Mounting - The appliance
should be mounted to a wall or ceiling only as
recommended by the manufacturer.
19.Power Lines - An outdoor antenna should be
located away from power lines.
20.Outdoor Antenna Grounding - If an outside
antenna is connected to the receiver, be sure
the antenna system is grounded so as to provide
some protection against voltage surges and built
up static charges.
Section 810 of the National Electrical Code,
ANSI/NFPA No. 70-1984, provides information
with respect to proper grounding of the mast
and supporting structure, grounding of the lead-
In wire to an antenna discharge unit, size of
grounding connectors, location of antenna-
discharge unit, connection to grounding electrodes,
and requirements for the grounding electrode.
See Figure below.
21.Object and Liquid Entry - Care should be
taken so that objects do not fall and liquids are
not spilled into the enclosure through openings.
22.Battery usage CAUTION - To prevent battery
leakage that may result in bodily injury, property
damage, or damage to the unit:
• Install all batteries correctly, with + and - aligned
as marked on the unit.
•
Do not mix batteries (old and new or carbon and
alkaline, etc.).
• Remove batteries when the unit is not used for
a long time.
23.Apparatus shall not be exposed to dripping or
splashing and no objects filled with liquids,
such as vases, shall be placed on the apparatus.
1