Chapter 2 General Operation; Switching On; Switching Off - James TVJ LED 39 F3300F Manual De Funcionamiento

Chapter 2

Switching on

Follow the instructions on this page on how to switch on your TV set and
the remote control before going on to following pages describing how to
use the channel set-up procedure.
1. Insert two AAA batteries in the remote control.
Precautions on using batteries:
- Only use the battery types specified.
- Make sure you use the correct polarity.
- Do not mix new and used batteries.
- Do not use rechargeable batteries.
- Do not expose batteries to excessive heat such as sunshine, fire or
the like, throw them in a fire, recharge them or try to open them, as
this could cause them to leak or explode.
- Remove the batteries from the remote control if you are not using it
for a long period of time.
2. Connect the power cable FIRST to the television, THEN to a mains
socket.
Your TV set should only be connected to an AC supply. It must not be
connected to a DC supply. If the plug is detached from the cable, do not,
under any circumstances, connect it to a mains socket, as there is a risk
of electric shock.
Note: The figures are for representation only. The location of the power
socket at the back of the television might differ depending on the model.
3. Connect an outside aerial to the ANTENNA IN socket at the back of
theTV set.
The aerial socket (75 OHM - VHF / UHF / cable) can be used for
connecting an external aerial or other equipment fitted.
Note: If you want to receive the signal from your cable or cable box,
please connect a coaxial cable to the CABLE IN socket at the back
of the TV set.
4. When powered on, the TV will be turned on directly or be in standby
mode.
If the power indicator lights up, the TV set is in standby mode. Press
the button on the remote control or on the TV set to turn on the TV.

Switching off

To put the TV set into standby mode, press the
control or on the TV, the TV set remains powered up, but with low energy
consumption.
To switch off the TV set, unplug the mains socket from the mains outlet.
8
General Operation
button on the remote