Craftsman 247.770120 Manual Del Usuario página 10

B
A
Figure 5
Figure 6
ASSEMBLY
aTTaCHing THe Bag
1. Grasp bag handle with one hand and slide locking rod on
mounting bracket with other hand toward engine. Use the end of
mounting bracket as leverage when sliding the locking rod.
2. Slip bag over the rim of the discharge opening and release
locking rod to secure bag in place. See Figure 5.
3. Snap bag clip to the top of the lower handle.
4. Place the lower straps on the bag over the top of lower handle,
hooking them on the studs. See Figure 6.
NOTE: The bag/chute switch button attached to the mounting bracket
must be fully depressed by the tip of front tab on bag handle when
securing the bag or engine will not start.
10