Danfoss ERC 213 Guía De Installación página 19

Parameter Name - ERC 213
Save settings as factory
WARNING: the earlier factory settings are
overwritten
DO2 config
dEF=defrost, ALA=alarm
Display at defrost
Air=actual air temperature,
FrE=freezed temperature, -d-="-d-" is displayed
Polarity
DI1 input polarity
nc=normally closed,
no=normally open
DI2 input polarity
nc=normally closed,
no=normally open
Invert alarm relay
0=normal, 1=invert relay action
Keyboard lock enable
Readouts
Controller Status
S0=cooling ON/Heating ON,
S2=wait for compressor ON time to elapse,
S3=wait for compressor OFF time to elapse-
restart time, S4=drip OFF delay after defrost,
S10=cooling stop S11=cooling stopped by
thermostat/heating OFF, S14=defrosting state,
S15=fan delay state after defrost, S17=door
open (DI input), S20=emergency cooling,
S25=manual control of outputs,
S30=continous cycle/Pull-down,
S32=delay of outputs at power up
Air temperature (Sair)
Read the present regulation reference
Defrost temperature (S5)
Note: hidden parameters are greyed out
DKRCE.PI.RL0.G7.ML
Code Min Max Unit
o67 no yES
o71 dEF ALA
o91 Air -d-
P--
P73 nc no
P74 nc no
P75 0 1
P76 no yES
u--
u00 S0 S32
u01 -100.0 200.0 C/F
u02 -100.0 200.0 C/F
u09 -100.0 200.0 C/F
Installation Guide | ERC 213
App. 0
App. 1 App. 2 App. 3 App. 4 App. 5 App. 6
(Def.)
no no no no
dEF ALA dEF dEF
-d- -d- -d- -d-
no no no no
no no no no
0 0 - -
no no no no
--
---
---
--- - - -
no no -
dEF dEF dEF
-d- -d- -d-
no no no
no no no
- - -
no no -
| 19