Engine Maintenance - Craftsman 580.752080 Instrucciones De Uso

Pump OiJMaintenance
DONOTattempt any oil maintenanceon this pump. This
model does not require any pump oii maintenance. The pump
is pre=iubricatedand sealed from the factory, requiring no
additional lubrication for the life of the pump.
ENGINEMAINTENANCE
WARNING
Unintentional sparking can result in fire or
_¢ electric shock.
WHEN ADJUSTmNG OR_IAKmNG R EPAmRS TOYOUR PRESSURE
WASHER
o Disconnect the spark plugwire from the sparkplugand place
the wire whereit cannotcontactsparkplug.
WHEN TESTING FORENGmNE SPARK
* Useapproved sparkplug tester.
. DONOTcheck for sparkwith sparkplug removed.
Oil
Oil Recommendations
NOTE:Use a high quality detergent oiI classified "For Service
SF, SG, SH, SJ" or higiler. DO NOT use speciai additives.
1. Choose a viscosity according to the table below:
104F_
86
68
50
32
14
4
-22
4O C
30
? 20
i lo
_ 0
-10
-20
-30
NOTE:Synthetic oii meeting iLSAC GF=2,APi certification
mark and APi service symboi with "SJ/CF ENERGY
CONSERVING"or higher, is an acceptabie oii at aii
temperatures. Use of synthetic oil does not alter required oil
change intervals,
SAE30: 40°F and higher (5°C and higher) is good for aii
purpose use above 40%, use below 40°F will cause hard
starting.
10W-31_: O to IO0°F (=18to 38°C) is better for varying
temperature conditions. This viscosity improves coid weather
starting, but may increase oil consumption above 80%
(27%),
*Check oii ievei frequently at higher temperatures,
Synthetic 5W-30:=20 to 120°F(=30to 40 °C) provides the
best protection at ati temperatures as well as improved
starting with iess oii consumption,
5W-30: 40°F and be_;ow (5°C and below) is recommended for
winter use and works best in cold conditions,
Checking Oil Level
OiI level should be checked prior to each use or at least ever,/
5 hours of operation. Keep oii ievei maintained.
1. Make sure pressure washer is on a ievei surface.
2. Remove oii dipstick and wipe dipstick with ctean cioth.
Reptaceand tigilten dipstick. Removeand and check oil
level.
3. Verify oiI is at "Full" mark on dipstick. Replace and
tighten dipstick.
1. Make sure pressure washer is on a level surface.
2. Checkoii ievei as described in Checking Off Level
3. if needed,siowiy pour oil into oil fiii opening to the
"Full" mark on dipstick. DO NOT overfill.
Overfiiiing with oil may cause the engine to not start, or
hard starting.
DO NOTovertill.
If over the FULL mark on dipstick, drain oil to reduce oil level to
FULL rnark on dipstick.
4. Replaceand tighten dipstick.
19