Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
FreshStart Fuel Cap
Adding fue! preserver helps keepfuei fresh and carburetors
clean for easier starting, ati season iong. This new fue! cap
automatically drips concentrated fuel preserver into your fuel
tank.
,, .DANGER
_///,,av/_ contact to eyes, skin or clothing. DONOTtake
internaliy. Avoid breathing the mist or vapor.
Overexposureto eyes or skin can cause irritation.
Keep stabiiizer out of the reach of children.
Fuel stabilizer is a hazardous chemical.**
If SWALLOWED, callphysicianimmediately.
h_the caseof an emergency, contacta physicianimmediately
and call1-800-424-9300 for material s afetyirfforrnation.
*Fuel stabilizer contains: 2,6-di-tret-butylphenol (128-39-2) and aliphatic petroleum
distillate (64742-47-8),
1.
Placecartridge into fuel cap.
/
,
jl
/
2.
Pushto <<snap" cartridge into place.
3.
Removetab to expose membrane.
IMPORTANT:DO NOT remove the silver foil seal oll the
opposite side.
4.
Reinstall fuei cap on fuel tank.
Periodicaliy check the cartridge to ensure there is still
fuel stabilizer inside. If it is empty, remove cartridge and
replace=
tti!lh llllitude
At altitudes over 5,000 feet (1524 meters), a minimum
85 octane / 85 AKi (89 RON)gasoiine is acceptable. To
remain emissions compiiant, high aititude adjustment is
required. Operationwithout this adjustment win cause
decreasedperformance, increased fuei consumption, and
increased emissions. See a qualified Sears deaier for high
altitude adjustment information. Operation of tile engine at
altitudes below 2,500 feet (762 meters) with the high altitude
kit is not recommended.
Cennect Hose and Water $upply te Pump
NOTE:Removeand discard the shipping caps from the
pump's high pressure outlet and water inlet before attaching
hoses.
1.
Uncoii higil pressure hose and attach one end of hose to
base of spray gun. Tighten by hand.
!tYAilIIIItll
igh pressure stream
ent produces can cut through skin and its
ying tissues, ieading to serious injury and
le amputation.
NEVER connecthigh pressurehoseto nozzleextension.
Keephigh pressurehoseconnected to pumpand spraygun
whilesystemis pressurized.
Alwaysbe certainspraygun,nozzles and accessories are
correctlyattached.
.
Attach other end of high pressure hose to high pressure
outlet on pump, Tighten by hand,
Publicidad
Tabla de contenido
