Stopping The Engine; Driving The Tractor; Stopping The Tractor - GOLDONI 900RS/DT Serie Manual De Manejo Y Cuidado

Starting using an oil booster.
In particularly cold weather, Model 926 RSDT can use an oil boost before
starting. Pour a few drops of the type of oil used in the engine in hole n.1 fig.6,
replace the plug n.2 and start the engine as usual.

4.3 STOPPING THE ENGINE

Pull knob n.26 fig.2; disengage the ignition key 5 turning it to 0.
Do not leave the tractor unattended with the key in the ignition.

4.4 DRIVING THE TRACTOR

The tractor has 9 gears: 6 forward and 3 reverse.
Release the handbrake (n.11 fig.1); push in the clutch (pedal n.2 fig.1 all the way
down)
Gear levers n.5-7 fig.1
n.5 = Range selector: Reverse (RM), Creep (R) and Fast (V).
n.7 = Gear select lever ( 1-4 2-5 3-6 )
With lever n.5 in Creep, you get 1st, 2nd and 3rd.
With lever n.5 in Fast you get 4th, 5th and 6th.
With lever n.5 in Reverse, you get 1st, 2nd and 3rd reverse.
To facilitate gear meshing, avoid the neutral position for lever n.5.
Engage the clutch by letting up pedal n.2 fig.1 slowly and gradually accelerate
the engine (pedal n.10 fig.1).
Do not ride the clutch as this will wear out the thrust bearing
Gears
CREEP RANGE AND
REVERSE LEVER
GEAR

4.5 STOPPING THE TRACTOR

a) Bring accelerator to minimum Rpm (release pedal n.10 fig.1 or pull lever n.4
fig.1 all the way back).
b) Depress the brake pedal.
c) PUSH in the clutch completely before the tractor comes to a complete stop.
d) Put the gear lever in neutral (levers n.5-7 fig.1) and put on the parking brake
(lever n.11 fig.1 pulled up).
SELECTING THE GEARS
1st 2nd 3rd
R R R
1-4 2-5 3-6
50
4th 5th 6th
REV
V V V RM
1-4 2-5 3-6 1-4
1st 2nd 3rd
REV REV
RM RM
2-5 3-6