Atp Baud Rate Setting Instructions - Adam ATP Manual Del Usuario

EN

8. ATP BAUD RATE SETTING INSTRUCTIONS

Please contact Adam Equipment to obtain the application tool required
1. Connect the ATP to your PC using the cable provided
2. Power ON the ATP
3. Open the ATP baud rate setting application
4. Select the COM port that your PC is using
5. Select the current baud rate that your ATP is set to(default is 9600)
6. Select your required baud rate from the drop down list on the right hand side
7. Click on "Set Default Baud rate"
8. Click Close
9. Power your ATP OFF and then ON again
© Adam Equipment Company 2016 9 3126611270RevB2-Nov12