Start-Up And Use; Starting The Appliance; Using The Freezer To Its Full Potential - Indesit Ufan 300 Instrucciones Para El Uso

Ocultar thumbs Ver también para Ufan 300:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 41

Start-up and use

Starting the appliance

GB
! Before starting the appliance, follow the installation
instructions ( see Installation ).
! Before connecting the appliance, clean the
compartments and accessories well with lukewarm
water and bicarbonate.
1. Insert the plug into the socket and ensure that the red
ALARM and green POWER indicator lights illuminate (the
TEMPERATURE ADJUSTMENT knob must not be on
2. Turn the TEMPERATURE ADJUSTMENT knob to the
"Super" position: the yellow SUPER FREEZE indicator
light will illuminate.
3. When the red indicator light switches off, turn the
TEMPERATURE ADJUSTMENT knob to a medium
position. The freezer is now ready to be used.

Using the freezer to its full potential

• Use the FREEZER OPERATION knob to adjust the
temperature ( see Description ).
• Do not re-freeze food that is defrosting or that has
already been defrosted. These foods must be cooked
and eaten (within 24 hours).
• Fresh food that needs to be frozen must not come into
contact with food that has already been defrosted.
Fresh food must be stored in the top FREEZER and
STORAGE compartment where the temperature drops
below -18°C and guarantees rapid freezing.
• Do not place glass bottles which contain liquids, and
which are corked or hermetically sealed in the freezer
because they could break.
• The maximum quantity of food that may be frozen each
day is indicated on the data plate, which is located inside
the freezer (for example: 4 kg per 24 hours).
• To freeze food (if the freezer is already in operation):
- For small quantities measuring less than half of the
value indicated on the data plate, turn the
TEMPERATURE ADJUSTMENT knob to the SUPER (rapid
freezing) position (the corresponding yellow indicator
light will illuminate), place the food inside and close the
door. After 24 hours, once the freezing process is
complete, turn the knob back to its normal operating
position.
- For large quantities measuring over half of the maximum
value indicated on the data plate, turn the
TEMPERATURE ADJUSTMENT knob to the SUPER
position 24 hours before placing the food you wish to
freeze inside. After another 24 hours, once the freezing
process is complete, turn the knob back to its normal
operating position.
! Do not open the door during freezing.
! If there is a power cut or malfunction, do not open the
freezer door. This will help maintain the temperature inside
12
the freezer, ensuring that foods are conserved for at least
9 -14 hours.
! Warning Indicator Light. When this red warning light
comes on for a prolonged period of time, it means that the
freezer is not functioning properly and the temperature is
rising too much. (Call your Service Centre)
This warning light might come on for a brief period when:
a) the door is left open for an extended period of time
(when the freezer is being loaded or unloaded).
b) the TEMPERATURE ADJUSTMENT knob is turned to
).
the "Super" setting.
In these two cases, the fact that the warning light comes
on does not indicate that the freezer is malfunctioning or
there is a defect.
Ice
ice tray
3
The fact that they are situated on the top part of the
freezer drawers ensures greater cleanliness: the ice no
longer comes into contact with the food placed inside
the freezer compartment; furthermore, the dripping of
the water during filling is avoided (a lid to cover up the
hole after filling with water is also provided).
1. Pull out the tray by pushing it up.
Check that the tray is ompletely empty and fill it with
water through the opening provided.
2. Take care not to exceed the level indicated (MAX
WATER LEVEL). Excess water prevents the ice cubes
from dispensing (if this happens, wait for the ice to
melt and empty the tray).
3. Turn the tray 90°: due to the connected compartments
each mould fills with water ( see diagram ).
4. Close the opening with the lid provided and put the
tray back, placing the top part in the corresponding
housing and allowing it to drop in again.
5. When the ice has formed (minimum time
approximately 8 hours) knock the tray against a hard
surface and wet the outside so that the ice cubes
come loose and take them out through the opening.
MAX
WATER LEVEL

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ufan 400

Tabla de contenido