Fcc Compliance And Advisory Statement; Disposal And Recycling - Elinchrom EL-Skyport Instrucciones Para El Uso

Troubleshooting
Should an error occur, first check the following points:
Having this problem? Check the following points:
Universal Receiver is not trig- Ø Check if the Transmitter is switched ON
gered by the Transmitter. Ø Check battery polarity
Mode "All" is selected Ø Check if the Receiver module is connected correctly to the unit
Ø Check if the frequency selector switch is set to the same
channel
Some Flash units are not Ø Check if the Channel selector switch is set to the same Group
triggered by the Transmitter Ø Reduce distance to any "not working" units
Mode "Grp" is selected
TEST flash works, but the camera Ø Check hot-shoe fitting
will not trigger Flash unit Ø Choose SYNC cable instead of hot-shoe connection
Distance range is too small Ø Reposition the unit
Ø Increase the distance to walls and ceilings
Ø Position the antenna of Transmitter and Receiver
Ø Use an RX extension cable to reduce the distance between
modules
CE Statements
This device has been tested and found to comply with the requirements set
up in the council directive on the approximation of the law of member states
relating to EMC Directive 89/336/EEC, Low Voltage Directive 73/23/EEC and
R&TTE Directive 99/5/EC
8

FCC Compliance and Advisory Statement

This device complies with Part 15 of the FCC rules. Operation is subject of the following two
conditions: 1. this device may not cause harmful interference, and 2. this device must accept
any interference received, including interferences that may cause undesired operation.
The equipment has been certified to comply with the limits for a Class B computing device
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable pro-
tection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed or used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined
by switching the equipment off and on. The user can try to correct the interference by the
following measures:
1. Reorient or relocate the receiving antenna
2. Increase the separation between the equipment and receiver
3. Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
4. Consult the dealer or an experience radio/TV technician for help Changes or modification
not expressly approved by the party responsible for compliance could avoid the user's
authority to operate the equipment.

Disposal and recycling

This device has been manufactured to the highest possible degree from materials
which can be recycled or disposed of in a manner that is not environmentally
damaging. The device may be taken back after use to be recycled, provided that
it is returned in a condition that is the result of normal use. Any components not
reclaimed will be disposed of in an environmentally acceptable manner.
If you have any question on disposal, please contact your local office or your local
ELINCHROM agent (check our website for a list of all ELINCRHOM agents world wide).
9