Control Panel - Mestra R-100139 Manual De Instrucciones

R-100140 is a practical Ultrasonic Bath specially designed for a wide range of applications. For a long working
life and an optimum performance, we recommend you to read carefully the following instructions:
INSTALLATION
Carefully unpack the Ultrasonic Bath. Inside you will find the following accessories:
1 power cord (K).
-
1 drain hose (L).
-
1 plastic basket (M).
-
▪
Choose a flat and firm surface far from heat or vibration sources.
▪
Connect the drain hose.
▪
Conecte el cable al aparato y el otro extremo a una toma de corriente de 230 V, 50 Hz provista de toma de
tierra.
▪
Connect the machine to a grounded 230 V, 50/60 Hz power supply.
▪
Remove the lid, put the items in the basket. Then put them in the cleaning tank. Add water or a cleaning
solution to a level between min. and max. and above the area to be cleaned. In order to prevent scratches
and friction of the products, do not pile them up.
▪
The machine is ready for operation.

CONTROL PANEL

Timer
10.
The timer counts down since the cleaning starts.
11.
Green
Orange
Red
Red blinking
All lighting
Set temperature
12.
5 temperatures can be selected. Press the key
secuence:
ºC / ºF indicator
13.
Overheat protection icon
14.
If the appliance is working improperly or has been operating for an excessive period of time, the
red warning light will illuminate, indicating that the overheating protection has operated. The
device can not be used for 15-20 minutes. Then the light will turn off and the device can be used
again.
Heating
15.
Press the key
twice to put heating off.
Normal cleaning
16.
When lighing: normal heating is acting.
To prevent accidental ignition of the heater, press the key twice in 6 seconds to turn it on or off.
17. On/Off :
8
State thermometer:
Water temperature between 0 and 30 % of the set temperature.
Water temperature between 30 and 60 % of the set temperature.
Water temperature between 60 and 90 % of the set temperature.
Temperature is near to set temperature.
Set temperature reached (90-100 %).
twice. Icon
will light, meaning that heating is active. Press again the key
EN
to select the temperature from the following