Wireless Lan - Fritz! WLAN 1750E Manual De Instalación Y Operación

Connecting the FRITZ!WLAN Repeater 1750E with
Wireless LAN at the Touch of a Button
Requirements (preconfi gured in and fulfi lled by a FRITZ!Box)
 Wireless access point that supports WPS with the WPA or WPA2 encryption standard
 The SSID (name of the wireless radio network) is set to "visible" in the wireless
access point, and the MAC address fi lter is disabled for the initial confi guration.
1. Insert the FRITZ!WLAN Repeater 1750E in an outlet in the vicinity of your wireless
access point (for instance, a FRITZ!Box).
2. Press the "WPS" button on the FRITZ!WLAN Repeater 1750E. The "WLAN" LED starts
to fl ash.
3. Within two minutes, press the button on your wireless access point that initiates
WPS. For more information, see the documentation of this device.
The FRITZ!WLAN Repeater 1750E adopts the SSID (radio network name) and the
network key from your wireless access point and establishes a secure wireless
connection. Once the connection has been established,the "Power", "WLAN" and " "
LEDs light up.
4. Insert the FRITZ!WLAN Repeater in an outlet located about halfway between your
wireless access point and the wireless devices to be added to the wireless network.
The FRITZ!WLAN Repeater 1750E is connected with your home network by wireless LAN.
Check the settings and perform an update if necessary. Continue reading on page 10.
8
1
2

Wireless LAN

Power
WLAN
LAN
4
3
9